ARMODD Silentwatch 5 Pro Bedienungsanleitung Seite 89

6. The smartwatch cannot be paired with a phone – possible
solutions:
- make sure the smartwatch and phone are charged
sufficiently
- make sure your phone's Bluetooth and GPS are switched
on and you have allowed your location/position to be
tracked in your phone's settings
- place the smartwatch and the phone next to each other
- check the system updates in your phone
- uninstall and re-install the app
- restart your phone and switch the smartwatch off then
back on again
- make sure your phone meets the technical requirements
(Android 5.1+, iOS 9.0+, Bluetooth 5.0+)
7. The green sensor light is blinking – data measurement
or transfer is underway.
8. The green sensor light blinks even when the smartwatch is not
being worn – it is not a flaw.
9. To ensure the correct functioning of the smartwatch, we re-
commend restarting or resetting the smartwatch occasionally
and, where a newer version is available, updating firmware in
the app. Make sure you always have the most recent version
of the app.
10. Always charge the smartwatch for no more than 2 hours (at no
more than 5 V). Improper charging reduces the capacity and
useful life of the battery. Battery life depends on the ambient
temperature and the number of functions actively running.
Running some functions may run the battery flat within se-
veral hours. Over time the capacity of the battery will reduce
naturally. If not used, do not leave the smartwatch flat for an
extended period of time and recharge the battery regularly.
11. Protect the smartwatch from falls or impact; do not expose it
to extreme temperature or direct sunlight. These conditions
EN CZ
89