Figure 4-5: Secureeasysetup Screen; Figure 4-6: Secureeasysetup Logo; Figure 4-7: Secureeasysetup Logo Location; Chapter 4: Setting Up And Connecting The Wireless-G Notebook Adapter Setting Up The Adapter - Cisco Systems Linksys WPC54G Kurzanleitung

Wireless-G Notebook Adapter
SecureEasySetup
With SecureEasySetup, setting up the Adapter is as simple as pushing a couple of buttons. Before you press any
buttons, though, you should locate the SecureEasySetup button on the device you're connecting the Adapter to,
such as a wireless router or access point.
1. Starting from the Available Wireless Network screen, click the SecureEasySetup button on the right hand
side.
2. You will be asked to locate the SecureEasySetup button on the device with which the Adapter will be
communicating. If you are not sure where to find this button, click Where can I find the button?.
This will walk you through a couple of screens to help you find the button, which is usually located on the
front of the wireless router or access point.
3. Press the Cisco logo or SecureEasySetup button on the wireless router or access point. When it turns white
and begins to flash, click the Next button on the Setup Wizard screen. The logo or button will stop flashing
on the wireless router or access point when the Adapter has been successfully added to the network.
Repeat this procedure for any additional SecureEasySetup device.
NOTE: You can only add one SecureEasySetup device at a time.
Chapter 4: Setting up and Connecting the Wireless-G Notebook Adapter
Setting up the Adapter

Figure 4-5: SecureEasySetup Screen

Figure 4-6: SecureEasySetup Logo

Figure 4-7: SecureEasySetup Logo Location

9