Hyundai WS 2468 Bedienungsanleitung Seite 23

• Press „MODE" to confirm your setting and to end the setting procedures.
Then it will return to the normal mode.
F.Y.I.:
• If there is no valid operation within 20 seconds, it will automatically return to normal time
mode from the set mode.
Setting the daily alarms:
• Press once „" button, LCD display the „
once „" button, the „
• Press once "MODE" button, LCD display alarm time, then Press and hold „MODE" button for
2 seconds until hour of the Alarm time starts to flash. Use the „" and „" buttons to set the
required hour.
• Press „MODE" button to confirm your setting. The Minute of the Alarm time starts to flash.
Use the „" and „" buttons to set the required minute.
• Press „MODE" button to confirm your setting, the snooze time of the Alarm starts to flash.
Use the „" and „" buttons to set the minute of snooze you need.
• Press „MODE" button to confirm your setting and to end the setting procedure.
F.Y.I.:
• If there is no valid operation within 20 seconds, it will automatically return to normal
time mode from the alarm time set mode.
• The alarm will sound for 2 minutes if you do not deactivate it by pressing any button.
In this case the alarm will be repeated automatically after 24 hours.
• Rising alarm sound (crescendo, duration: 2 minutes) changes the volume 4 times whilst
the alarm signal is heard.
Switching off the alarm signal
• When the alarm is ringing, press any button except the "SNOOZE/LIGHT" button to stop the
alarm signal. It is not necessary to reactivate the alarm. It will ring again this time next day.
Snooze function
• When the alarm is ringing, touch the "SNOOZE/LIGHT" button the alarm mode will to
get to SNOOZE mode. The alarm signal sounds again after already been set.
RF Transmission Procedure:
• The weather station automatically starts receiving transmission from outdoor thermo sensor
for outdoor temperature & humidity after batteries inserted.
• The remote sensor will automatically transmit temperature and humidity signal to the Weather
Station after batteries inserted.
• If the Weather Station failed to receive transmission from outdoor sensor („- -.-"display on the
LCD), press and hold „" button for 3 seconds to receive transmission manually.
RF icon „ " flashes on the LCD. The Weather Station to receive the remote sensor.
" icon, the alarm function is ON, Then press
" icon will disappears from the display, the alarm function is OFF.
EN - 23
EN