Transport And Packaging; Appliance Equipment; Installation - BOMANN KSG 7280.1 Bedienungsanleitung, Garantie

Coolant
WARNING: Risk of fire / flammable
materials
The coolant circuit of this unit contains the refrigerant
Isobutane (R600a), a natural gas that is flammable
and of high environmental compatibility. Make sure
no parts of the coolant circuit get damaged during
transport and installation of the appliance.
If the coolant circuit is damaged:
• avoid any open flames or ignition source,
• disconnect the plug,
• thoroughly air the room in which the appliance is
installed and
• contact an authorized technician.

Transport and Packaging

Transport the appliance
Transport the appliance, if possible, in vertical posi-
tion. Otherwise, it is absolutely necessary to allow
the appliance standing upright for a few hours before
"Prior to first use"

installation

during transport against weather influences.
NOTE:
The appliance has wheels, which make it easier for
you to transport or install the appliance. Tilt the appli-
ance slightly backwards and move it carefully.
Unpacking the appliance
• Remove the appliance from its packaging.
• Remove all packaging material, such as foils, filler
and cardboard packaging.
Dispose of packaging materials that are no longer
required in accordance with the locally applicable
regulations.
• To prevent hazards, check the appliance for any
transport damage.
. Protect the appliance
• In case of damage, do not put the appliance into
operation. Contact your distributor.
NOTE:
Production residue or dust may have collected on the
appliance. We recommend cleaning the appliance
according to chapter

Appliance Equipment

Appliance overview
1 Temperature control, interior light + light switch
(max. loading 35 kg/shelf)
2 Grid shelves
3 Feet
Delivery scope
5x grid shelf, 1x door stopper
opening)
Conditions for the installation location
• Good ventilation is required around the appliance
to dissipate the heat properly and to guarantee ef-
ficient cooling operation at low power consump-
tion. Enough clearance is necessary.
Gap to the back approx. 50～70 mm, to the
-
side walls and above the appliance each ap-
prox. min. 100 mm;
17
"Cleaning and Maintenance"
(for reversing the door
Installation
.