Inhaltsverzeichnis
Werbung
Levenhuk Wezzer Cook MT30 Cooking Thermometer
EN
Levenhuk Wezzer digital cooking thermometers are designed for the temperature measurement of various types of food and dishes
during the cooking process.
Clean the probe thoroughly before and after every use.
Using. Press (5) to turn the device on. Press (5) again to turn the device off. Insert the tip of the probe at least 1cm into the measured
material. The current temperature will be shown on the display (2). Wait a few seconds to let the temperature stabilize. Press (3) to
change the temperature unit (Celsius, °C / Fahrenheit, °F). Press (3) to turn on the backlight.
Capture the current temperature. Before withdrawing the probe from food, press (4) to hold the temperature reading.
Suggested temperatures for various meat types and degrees of doneness:
Meat type
Ground Beef
Ground Poultry
Beef
Veal
Chicken/Poultry
Pork
Lamb
Fish
Specifications
Operating temperature range, °C/°F
Waterproof
Probe length, mm
Power supply
The manufacturer reserves the right to make changes to the product range and specifications without prior notice.
Care and maintenance
Never leave the thermoprobe inside a working oven or microwave, remove the device immediately after measuring the
temperature. Keep the device away from open flames and hot surfaces. Always wear protective gloves during and after using
the thermoprobe due to the risk of burns. After each usage, wash the steel probe in soapy or running water. Place the steel
probe in hot water for a few minutes in order to sterilize it. The device is not dishwasher safe. Never use a damaged device.
Use the device only for its intended purpose. The device is suitable for indoor use only. Strictly follow the instructions and
do not disassemble or drop the device as it may result in a loss of functionality. Children should use the device under adult
supervision only.
Battery safety instructions
Always purchase the correct size and grade of battery most suitable for the intended use. Always replace the whole set of batteries
at one time; taking care not to mix old and new ones, or batteries of different types. Clean the battery contacts and also those of the
device prior to battery installation. Make sure the batteries are installed correctly with regard to polarity (+ and –). Remove batteries
from equipment that is not to be used for an extended period of time. Remove used batteries promptly. Never short-circuit batteries
as this may lead to high temperatures, leakage, or explosion. Never heat batteries in order to revive them. Do not disassemble
Doneness
Well done
Well done
Well done
Medium Well
Medium
Medium rare
Rare
Well done
Medium Well
Medium
Medium rare
Rare
Well done
Well Done
Medium Well
Medium
Well done
Medium Well
Medium
Medium rare
Rare
Well done
°C
71°C
74°C
77°C
71°C
66°C
60°C
52°C
74°C
71°C
66°C
60°C
52°C
74°C
77°C
74°C
71°C
77°C
74°C
71°C
63°C
60°C
63°C
–50... 300/–58... 572
IP66
145
1pc CR2032 battery
3
°F
160°F
165°F
171°F
160°F
151°F
140°F
126°F
165°F
160°F
151°F
140°F
126°F
165°F
170°F
165°F
160°F
171°F
165°F
160°F
145°F
140°F
145°F
Werbung
Inhaltsverzeichnis
