7/ Maintenance - tecsup BABY Bedienungsanleitung

Screen
The LED plastic screen (polycarbonate 2 mm thick) is almost
indestructible, but the state of the screen can interfere with the
quality of the light available. Clean the screen regularly, with a non
abrasive cloth. It would be wise to replace the screen when needed
during the life of the lamp. It is a very simple operation, where only
a TORX 10 screwdriver is needed.
Storage
Be sure to optimise the Lithium battery pack, by not leaving the
product stored with the batteries discharged.
We also advise you to not expose the product to very high
temperatures.
Avoid storing for a period of:
- 1 week at T° superior to +50°C
- 1 month at T° superior to +45°C
- 6 months at T° superior to +40°C
Connector
The connector for recharging from mains is lubricated at the factory.
Make sure to re-grease it if necessary, using a grease for contact
type SGB (ELECTROLUBE®)
WARNING: Always connect the power connector to the projector
before connecting it to the wall outlet. And always unplug the wall
outlet before removing the charging connector
Seal
In order to ensure the tightness of the BABY, be sure to check the
cleanliness of the seal and if necessary lubricate the seal with a
silicone-type grease.
TECSUP - BABY - Manuel utilisateur - 80300106 L - P 28 / 50

7/ MAINTENANCE

The screen must be replaced if it is cracked or
broken.
BABY