5/ Three Ways Of Recharging; On Mains Power Or Via A Generator; On A Car Cigarette Lighter - tecsup BABY Bedienungsanleitung

BABY

5/ THREE WAYS OF RECHARGING

5.1 On mains power or via a generator

Plug-in the mains power cable (found inside the case) and connect
to "secteur/mains" socket. The wide range of input voltages allows
this product to be charged on any monophase current, anywhere
around the world. Use an interface if needed or buy a specific mains
cord to your local country.
Once the charge is finish, unplug and make sure the protective
waterproof caps are screwed onto the sockets.
The charging time depends on the temperature inside the BABY.
To optimize the reliability of electronics, a derating of the charging
will operate according to the internal temperature. To optimize
charging, TECSUP recommends opening the lid for a quick recharge.

5.2 On a car cigarette lighter

Plug-in the cigarette lighter cable (found inside the case) and
connect to the "entrée 12VDC". Your vehicle cigarette lighter must
be protected by a 6A fuse minimum; the majority of car cigarette
lighters are protected by a 10A fuse, so this point should not be a
problem.
Once the charge is finished, unplug and make sure the protective
waterproof caps are screwed onto the sockets. Replace the cables
inside the case.
In the event that you don't need to use your BABY Led Light for
long periods (months), we advise you to keep the light plugged into
the mains or your cigarette lighter indefinitely. This will ensure that
the batteries are always fully charged and ready for use.
TECSUP - BABY - Manuel utilisateur - 80300106 L - P 25 / 50