As A Lamp With "Back-Up Power", Plugged Into Mains Power; In Mode "Stand-By", Plugged Into Mains Power - tecsup BABY Bedienungsanleitung

BABY
4.2 As a lamp with "back-up power", plugged into mains
power
BABY is plugged into the mains power and switched "On", (E=100%,
50%, 15%, "Beacon", "SOS", depending on users choice).
- If the mains power disappears, BABY passes automatically to
"back-up" mode on the battery pack and the autonomy will depend
on the remaining battery charge level.
- If the mains power returns, BABY turns back to mains power
supply without altering the power of light, 100%, 50%, 15%,
"Beacon", "SOS", chosen by the user; simultaneously, the battery
will begin to recharge itself. The charging time depends on the
temperature inside the BABY.
>>> Typical cases of use: emergency lighting unit, evacuation
light, critical interventions, etc.

4.3 In mode "stand-by", plugged into mains power

The «stand-by» mode is obtained by holding down the "Lighting"
button for more than 3 seconds. The lamp must be switched on
during this action.
The blue flashing led confirms the operation.
BABY is plugged into the mains power on the "Off" position. When
mains power is present, the light remains off, the charger maintains
the battery charge level at its maximum.
- If mains power disappears, the lamp will light up automatically,
powered by the battery pack.
- The moment the mains power returns, BABY switches off,
recharging the battery while remaining in "stand-by" mode. At the
same time, the battery completes its recharge.
When the first power-cut occurs, the autonomy of the light has
been voluntarily limited to 2hrs30, the light will then switch off,
this is to preserve battery power by keeping reserve power. Thus,
if mains power disappears again (after 30sec minimum), BABY will
light up and will continue to function for 2 hours.
>>> Typical uses : events/shows, emergency evacuation, back-up
lighting, etc.
TECSUP - BABY - Manuel utilisateur - 80300106 L - P 24 / 50