ofinto Elevate Bedienungsanleitung Seite 21

USE
INITIALIZATION
When the ofinto Elevate is used for the first time, the system
must be initialized. To do this, simultaneously hold down the
and keys until the table has reached its lowest possible
^
height and you hear a short beep (takes about three se-
conds).
HEIGHT DISPLAY
The display of the control panel shows the current height
of the table top. This display works both in centimeters and
inches. To change the unit system, press and hold the ,
1 2
and keys simultaneously until «C-E» flashes on the dis-
M
play. Then, press the key for centimeters or the key for
1 2
inches.
ADJUSTING THE TABLE HEIGHT
The control element allows you to set the table height using
the and keys. On the display, you can see the current
^
height of the table top.
MEMORY FUNCTION
You have the option of saving up to four table positions for
later use. To do this, use the arrow keys to set the desired
E
height and then press and hold the key until the number
M
on the display starts to flash. Then, press the , , or
1 2 3 4
key to save the current table position under this key., um die
die Höhe unter dieser Taste zu speichern. The height remains
stored even when the table is temporarily without power.
21