Dynamic Label Plus; Manual Setting; Inactive Stations; Volume Adjustment (Drc) - TechniSat DIGITRADIO 216 Bedienungsanleitung

7.2.7 Dynamic Label Plus

Where supported by the broadcaster, the Dynamic Label Plus service also allows, for example, the name of
the current programme or the track and artist to be displayed. Further information can be found under 5.4.3.

7.2.8 Manual setting

This menu item is used to check the reception channels and can be used to position the antenna. If
stations are found on the channel, these are added to the station list. In the [Manual setting]menu item,
use the < or > buttons and SELECT to select a channel (5A to 13F) and view a display of the signal strength.
Where DAB is received on a channel, the ensemble name is displayed. The antenna can now be aligned to
the maximum signal intensity.

7.2.9 Inactive stations

This menu item is for removing old stations and those not being received from the station list.
> Keep pressing the MENU button and select the [Inactive Stations] menu item.
> Confirm by pressing SELECT.
You are then asked if inactive stations should be deleted.
> Use < or > to select "Yes" and confirm by pressing SELECT.

7.2.10 Volume adjustment (DRC)

The compression rate can be set using the Volume Adjustment menu item, which balances the dynamic
variations and thereby the accompanying volume variations.
> Press the MENU button for longer and select Volume Adjustment to choose the desired compression
rate. Select the compression rate using < or >:
DRC high -
DRC low -
32
High compression
Low compression