Safety Instructions; Description And Function; Product; Scope Of Delivery - Wentronic WTS-E 2 A QC 3 C PD-1 Einbau- Und Betriebsanleitung

1

Safety instructions

The manual is part of the product and contains important information for correct use.
• Read the manual completely and carefully before use.
The manual must be available for uncertainties and passing the product.
• Keep this manual.
Risk of electric shock
• Do not use the product with wet hands.
• Pay attention to the maximum output currents of the product.
• Do not open the housing.
• Do not modify product and accessories.
• Do not short-circuit connectors and circuits�
• Do not insert foreign objects or fingers into the connection sockets.
• Make sure that no liquids get into the connection sockets.
Do not operate a device if it is not in working order. In such cases, it must be secured against
unintentional further use.
• Use product, product parts and accessories only in perfect condition.
• In case of questions, defects, mechanical damage, trouble and other problems, non-
recoverable by the documentation, contact your dealer or producer.
• The connection cables must not be subjected to tension�
Target group information
Caused to different risk levels and hazard potentials some working steps only may be done by
trained specialists.
Work on the on-board electrical system may only be carried out by trained specialists. Impro-
per execution of electrical connections in the vehicle can lead to considerable danger.
The vehicle's controls must not be impaired by the installation and use of the product.
• Let only qualified personnel perform installation, disassembly, maintenance and re-
pair work.
• Observe the general health and safety regulations for all work�
Not recommended for children and people with physical and / or mentally limited capabilities.
• Secure the product against accidental use.
• Secure packaging, small parts and insulation against accidental use.
Short circuit to ground
• Do NOT hook up devices connected to the product to the vehicle via other interfaces
at the same time�
• The connection sockets must not be connected to another voltage source�
2

Description and Function

2.1 Product

The product is a USB charger for installation in motor vehicles such as motor homes,
passenger cars and trucks. It has a USB-C™-PD socket (PD = Power Delivery) and a USB-
A-QC3.0 socket (QC = Quick Charge). The USB charger is used to charge and operate USB
devices via the on-board power supply. It converts on-board voltage into 5 V, 9 V and 12
V voltage�
The USB charger may only be connected to electrical systems with 12 to 24 V direct cur-
rent�

2.2 Scope of Delivery

USB-Charger Type A + Type C, Rubber ring, Locking ring, Installation and User Manual
10