Using Your Ageloc Lumispa Io; Cleaning And Care After Every Use - ageLOC LumiSpa iO Gebrauchsanleitung

EN
USING YOUR AGELOC® LUMISPA® iO
STEP 1
• Moisten face with water.
• Apply an ample amount of ageLOC LumiSpa
activating cleanser to all areas of the face, avoiding
eyes and lips.
STEP 2
• Wet Silicone Head by placing it under running
water.
• To start an application, press the Power button.
• Gently glide the Silicone Head back and forth in
slow, broad strokes over one of the areas of your face.
Note: If you use a scrubbing motion or press too hard, the
device will pause and vibrate to remind you to apply normal
pressure and resume slow, broad strokes.
• The back lights indicate the current application
zone. The device will pause briefly between each
of the four zones, and the lights will progress to
prompt you to move to the next area.
STEP 3
• When the application is done, the device will
stop.
• The device will turn off automatically.
1
• Rinse your face with water to remove residual
activating cleanser.
2 4
Note:
3
• If at any time you would like to pause your application,
press the Power button once. Unpause your device by
pressing the Power button again. To manually turn off the
device, press and hold the Power button.
• ageLOC LumiSpa iO is safe to use in the shower or wet
environment. However, the magnetic charger should not
be exposed to water.
• ageLOC LumiSpa iO is suitable for makeup removal.
However, do not use the device for cleansing around the
eye area. Use ageLOC LumiSpa iO Accent System for
targeting the delicate skin around the eyes.
8

CLEANING AND CARE AFTER EVERY USE

• Remove the Silicone Head from the device.
Rinse it with water while rubbing to remove
residual activating cleanser. Dry thoroughly.
• Rinse device under water.
• Wipe device dry.
• Only reattach the Silicone Head to the device
after both components are thoroughly dry.
EN
9