Cresta DTX500 Bedienungsanleitung Seite 40

NOTES: NOTES: NOTES: NOTES:
First insert the batteries of main unit, then insert the batteries of the outdoor sensor in 3
•
minutes after the main unit is powered on, to assure of the sensor data received well.
In case of the outdoor sensor data received failure, pls press
seconds to synchronize the RF signal.
• Every time the batteries are replaced , the main unit will loose all the weather data.
Every time the batteries are replaced , the thermo-hygro sensor will sychronize with the main
•
unit again, you must press the
Mounting the
• • • • Mounting the Mounting Mounting the the main
The main unit can be placed onto any flat surface or wall mounted at the desired location by
hanging hole, It is important to check that the radio signal can be received before mounting.
• • • • Mounting the Mounting Mounting Mounting the the outdoor the
For accurate results, the outdoor sensor mast should be securely mounted onto a horizontal
surface and in an open area away from trees and other coverings where rainfall or wind
speed may be reduced causing inaccurate reading.
1. Mounting Mounting Mounting the Mounting the wind the the
can rotate freely before fixing . The wind speed sensor should now be mounted onto the
bracket provided to allow the wind to travel around the sensor unhindered from all
directions.please follow the below display :
␇ ␇ ␇ ␇
key for more than 3 seconds to synchronize the RF signal.
main unit
main main unit unit unit
outdoor outdoor outdoor sensor sensor sensor onto sensor onto the onto onto
wind wind speed wind speed speed speed sensor sensor sensor to to to to the sensor
␇ ␇ ␇ ␇
key for more than 3
the the the stainless stainless stainless steel stainless steel steel mast steel
the the first the first first plastic first plastic bracket plastic plastic bracket bracket：first check the wind-fan bracket
mast mast mast