Min/Max (format int)
Speed Minimum
31
Drehmoment Minimum
63
Tabelle 8-17 Min/Max (format int)
After the zero point calibration procedure the status bit 'zero point reset' is
set. It can only be cleared by resetting the status word. With the help of the
error code it is possible to check whether the command is accomplished
successfully or not.
Error 0/1:
Error 1
0
1
Tabelle 8-18 Error 0/1
Selection 0/1:
Selection 1
0
0
1
Tabelle 8-19 Selection 0/1
114/160
16
15
48
47
Error 0
1
0
Selection 0
0
1
0
Speed Maximum
Drehmoment Maximum
Nullpunktrücksetzung nicht
möglich
Kein Kalibrationssprung
Md1 / N1
Md2 / N1
Md1 / Md2
ATESTEO
Manual F-Serie, iS-, i-, eS-Type – Version 2019/05
0
32