First Start-Up - Zibro Arabella Gebrauchsanweisung

Picture 2: Primary Air inlet.
cal legislation and/or insurance compan� instructions: make sure that at least once
per �ear at the beginning of the heating season �our entire stove s�stem �including
chimne�� is checked and maintained b� an authorized specialist. When intensivel�
using the stove the chimne� must be cleaned more frequentl�.
c. FiRsT sTART UP
G
Before starting the stove remove all items such as manual paperwork,
gloves (if applicable), stove tool etc. from the fire hearth / fire bed.
after completion of new building or refurbishment: have the building dried ex-
tensivel� before using the stove for the first time. Walls, ceilings and/or floors are
known for its long time before the� are completel� dr�. Soot, ash parts etc might
easil� stick to not completel� dried walls.
The stove is made out of high qualit� steel protected with a coating. During first
heating c�cles the coating will harden and the steel will set itself. This process takes
some time. in order to prevent permanent damage to the stove this initial stoking
up must be done graduall� and at low fire. Keep this low fire for the first four to
five hours after which the capacit� graduall� can be increased. Keep the stove con-
tinuousl� burning for at least another three to four hours. During first operation
it is normal that an unpleasant though non harmful odour will be produced. the
above described procedure must be followed for at least the first four times the
stove is used.
Make sure to ventilate the room sufficientl�.
D. nORMAL OPERATiOn OF ThE sTOVE
to start the stove:
Full� open the door and the primar� inlet valve (see picture 2) b� turning the valve
to "+". place and lit some crumpled paper or fire lighter sticks (fire starter sticks)
in the fire bed together with some small size dr� fire wood (for fuel requirements:
see chapter d.3)
do not use liquid fuel, such as for example alcohol, petrol, gasoline etc to
start the fire.
The flame and performance of the stove can be controlled b� moving the primar�
air inlet valve simpl� follow the + and – signs (see picture 2).
When starting the fire the chimne� and exhaust flue is still cold, due to which there
will onl� be little draught. Create enough start up draught b� keeping the ash pan
(little), the stove charging door (little) and the primar� air inlet (maximum) open
during the first eight to ten minutes.
after these eight to ten minutes the fire will burn more extensive, now place big-
ger fire wood. close ash pan and stove charging door to a minimum.
4
55