Headphone Output; Speaker Outputs - Ashdown Engineering ROOTMASTER EVO II Bedienungsanleitung

ROOTMASTER EVO II
USER GUIDE
Effects send/return
A serial effects loop is provided at a level of 0db. The effects send and
return sockets for this are on the rear panel above the d.I. Socket.
The effects send socket can also be used as a line out socket if required.
The signal path through the preamp is only broken when a jack plug is
inserted into the effects return socket. The effects send is situated after
the E.Q.
Line In
This input socket provides a line level signal that can be used in conjunc-
tion with the Line in Level control on the front panel for connecting a line
level instrument of playback device.
FS-2 Output
The FS-2 Output is for use with a double latching foot-swtich, this controls
the Sub Harmonics and also the Drive for ease of access (foot-switch sold
separately).

Headphone Output

There is a 32 ohm headphone output on the rear panel for use in silent
practice.

Speaker Outputs

There are two speakon out sockets located on the rear of the amp for use
with appropriate cabinets. Min load of 4 ohms. All speaker connections
used must be of the speakon type and fully insulated. These amplifiers