Inhaltsverzeichnis
Werbung
water, in order to have a clear indentation between
the elements (FIG Z).
Minor Dents
Transportation and handling can cause minor dents to
the product. This can be repaired with the powder glue
which is included. For a perfect result you can fill and
grind with a suitable filler on top of the powder glue.
Fill smaller cracks and uneven surfaces with a float or
a brush. If the dent is deep, it is recommended to fill in
several stages to avoid sinking. Even out with e.g. a
damp sponge or a float.
Painting
The surface of the surround is developed to be painted
without priming work. Use latex or acrylic based paint
(emulsion paint), or cement-based textured paint.
In the unlikely case that there are some irregularities in
the surface, these can be filled with the acrylic which is
included, or a light and appropriate filling material.
Any surface that has been filled needs to be
smoothened with fine sand paper.
Polishing
If a more traditional and polished surface is wished for,
it is recommended to dampen the surround and then
cover it with tile adhesive (powder glue) and a fibreglass
mesh, prior to possibly adding mortar or mineral polish.
Tiles
This fireplace can also be partially or completely
covered with tiles / natural stone of your choice. As for
the section above on "Polishing", we recommend that
the chimney surround is dampened before it is covered
with tile adhesive (powder glue) and a fiberglass mesh.
This is to ensure good adhesion and prevent the
formation of cracks at the joints of the surround.
Please note that the adhesive and mortar must
set before burning in the fireplace. Follow the
instructions from the mortar/adhesive producers.
Regardless of surface treatment it is advantageous to
mask the entire door frame to avoid having to clean it later.
Please note that the air gap between the surround
and the door frame must not be filled with glue,
mortar or similar.
Thermotte™
The insulation plates (Thermotte) are classified as "wear
and tear" parts which will require to be exchanged after
some years. The wear time will depend on the individual
use of your product. Nordpeis offers a one-year
warranty on these parts. After this, replacements can be
purchased.
Please note: Wood logs that are too long can cause
additional strain and crack the plates, due to the tension
created between the side plates.
4
Cracks in the i PowerStone
Due to thermal effects there may be small cracks /
fissures in the PowerStone. This is natural and does not
affect the product's function or safety.
2. Warranty
Use replacement parts recommended only by
the Manufacturer.
Any unauthorized modification of the appliance
without written permission of the Manufacturer
are prohibited.
For detailed description of the warranty conditions see the
enclosed warranty card or visit our website
www.nordpeis.com
Recycling of the refractory glass
Refractory glass cannot be recycled. Old glass,
breakage or otherwise unusable refractory glass, must
be discarded as residual waste. Refractory glass has a
higher melting temperature, and can therefore not be
recycled together with glass. In case it would be mixed
with ordinary glass, it would damage the raw material
and could, in worst case end the recycling of glass. It is
an important contribution to the environment to ensure
that refractory glass does not end up with the recycling
of ordinary glass.
CERAMIC GLASS
CANNOT BE
RECYCLED
Ceramic glass should
be disposed of as resid-
ual waste, together with
pottery and porcelain
Packaging Recycle
The packaging accompanying the product should be
recycled according to national regulations.
Door and Glass
Should there be any soot on the glass it may be
necessary to clean it.
as other detergents may damage the glass/gaskets.
(Attention! Be careful, even dedicated glass cleaner can
damage the varnish on the door frame and
A good advice for cleaning the glass is to use a damp
cloth or kitchen roll paper and apply some ash from the
burn chamber. Rub around the ash on the glass and
finish off with a piece of clean and damp kitchen roll
paper. Attention! Only clean when the glass is cold.
GB
Warning!
Warning!
Use dedicated glass cleaner,
gaskets).
Werbung
Inhaltsverzeichnis
