Control Panel; Installation Instructions - Comedes Demecto 30 eco Bedienungsanleitung

Control panel

Figure 3: Displays
Sleep
Fan-
speed
Display
Display:
The illuminated display shows the prevailing room humidity as soon as the unit is plugged in.
During the setting of the timer and the target humidity, the selected values are displayed.
After the setting is completed, the current room humidity is displayed again. If the current
value is below 20%, the display shows "LO", the compressor stops and the fan continues to
operate. If the current value is above 90%, the display shows "HI".

Installation instructions

Operate the appliance only in rooms with at least 6m².
Floor space
 Remove all adhesive tapes that were used to secure the unit for transport.
 Check that the unit is standing securely on firm, level and dry ground.
 Never install the unit where it may be exposed to the following conditions:
Heat sources such as radiators, heat registers, stoves or other products that
o
generate heat.
In an area where oil or water may be splashed.
o
Direct sunlight
o
Mechanical vibrations or shocks
o
Excessive dust exposure
o
Escaping flammable gas
o
Lack of ventilation, e.g. in the cupboard or bookshelf
o
Uneven surface
o
 Make sure that the socket outlet is equipped with an RCD circuit breaker (ground fault cir-
cuit interrupter). If you are not sure whether this is the case, you can ask your
electrician or use a personal protection plug (available in DIY stores).
 To save power and avoid potential hazards, unplug the unit when not in use.
 Keep at least 50cm distance around the unit from walls and objects. Make sure that the air
outlet is clear and that there are no curtains or textiles above it.
min. 50cm
Child lock
Display
Filter-
display
min. 50cm
Timer
Tank
"full"
Automatic mode
min. 50cm
Continuous operation
Operating display
min. 50cm
ENG-8