VONROC VC508DC Originalbetriebsanleitung Seite 11

Remove all dirt and debris from the
container (8) before you use the blow
function.
Your vacuum cleaner is equipped with a blowing
function. It can be used to blow dust and debris
out of garages or off patios and driveways. We re-
commend using the crevice nozzle (19) for stronger
airflow.
1. Press the power switch (1) into the "OFF/0"
position and remove the battery.
2. Unlock the locking clamp (6) and remove the
top section (7).
3. Before blowing, remove the dust collection bag
(17), the filter (13, 14) and remove all dirt and
debris from the container (8).
4. Reattach the top section (7) again and lock the
locking clamp (6).
5. Insert one end of the hose (12) into the blowing
port (9) at the rear of the machine. Fully unwind
the suction hose (12).
6. Insert the battery (4).
7. Press the power switch (1) into the "ON/I" posi-
tion to start your vacuum cleaner.
8. The machine is now ready for blowing dust and
debris.
9. Press the power switch (1) into the "OFF/0"
position to switch off your vacuum cleaner.
Finish operation
1. Press the power switch (1) into the "OFF/0"
position to switch off your vacuum cleaner.
Remove battery.
2. Remove the top section (7) and empty the con-
tainer (8).
3. Clean the machine with a soft cloth and store in
a dry room.
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
battery from the machine.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that the
ventilation openings are free of dust and dirt. Re-
move very persistent dirt using a soft cloth moiste-
ned with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
WWW.VONROC.COM
Container
Empty the container (8) immediately after suction
cleaning because it is not designed to store liquids.
1. Remove the top section (6) and empty the
container (8).
2. Clean the machine with a soft cloth.
Filters
For optimal performance it is recommended
to regularly change the filters (13, 14)
depending on level of use.
Hepa filter:
1. Carefully remove HEPA filter (14).
2. Clean the surface of the filter with a brush.
3. Wash the filters gently with water under 40 de-
grees.
4. Allow filter to air dry before installing and using
again.
5. Re-install the filter.
Foam filter:
1. Carefully remove foam filter (13).
2. Wash the filters gently with water under 40
degrees.
3. Allow filter to air dry before installing and using
again.
4. Re-install the filter.
Float and filter cage
Clean the float (16) and filter cage (15) regularly
with a soft cloth, and check it for damage. Otherwi-
se, its function can be impaired.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EU
for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
EN
11