Herunterladen Inhalt Inhalt Diese Seite drucken

Description Of The Appliance (Fig. 1) - eta Power Care Bedienungsanleitung

Massagepistole
Vorschau ausblenden Andere Handbücher für Power Care:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 30
EN
– Never immerse the adapter into water or other liquids (not even partly) and do not wash it in running
water!
– Charge the battery at a temperature close to the room temperature.
– Do not dispose the battery into fire. There is a risk of explosion!
– Never charge the appliance in direct sunlight or close to heat sources, and if the temperature is below
10 °C or above 40 °C, adversely affects the accumulator service life.
– Prevent hanging the power adapter cord loosely over desktop edge where children may reach it.
– The power cord of the adapter must not be damaged with sharp or hot objects or open fire, and must not
be immersed into water or bent over sharp edges.
II. DESCRIPTION OF THE APPLIANCE (Fig. 1)
A – Massage gun
A1 – charging socket
A2 – ON / OFF button and intensity switching
A3 – vibration intensity indicators
A4 – handle
A5 – inlet for extensions
B – Massage attachments
B1 – round extension
B2 – conical extension
B3 – fork attachment
B4 – flat attachment
C – USB cable *
D – Protective case
* USB cable: A source with USB terminal may be connected to USB cable (for example AC power adapter,
backup power source, etc.).
III. INSTRUCTIONS FOR USE
Before using the appliance, its battery must be charged first. Charging is possible with the enclosed USB
cable from the mains, i.e. an AC adapter, or a backup power source.
CHARGING
– Before the first use or if the appliance was not used for a long time, charge it completely.
– The standard charging time is approximately 2 hours. and the fully charged accumulator allows for the
operating time of up to 180 minutes. The operating time decreases depending on the appliance loading
and due to the accumulator ageing and wear and tear.
1. Make sure the appliance is switched off.
2. Connect the enclosed USB cable to the power supply terminal, and connect the other side to a power
source, for example to a compatible AC power adapter, or to a backup power source. While charging,
the appliance cannot be in use. If the appliance is turned on and you start charging, the appliance shall
switch off.
16
/ 35

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

1660

Inhaltsverzeichnis