Comedes Demecto 70 Bedienungsanleitung Seite 30

Maintenance log for Comedes Demecto 70:
Serial number: ........................................
Maintenance and
service interval
Check air inlet and
outlet and remove
impurities.
Exterior cleaning
Visual inspection of
the water outlet (hose
connection) for
contamination
Check air filter for dirt
and foreign bodies,
clean or replace if
necessary
Check the unit for
damage (power cable,
housing, tank, fan
wheel)
Check fastening
screws
Trial run
Empty tank or check
hose drainage
1. Date:
Signature
5. Date:
Signature
9. Date:
Signature
13. Date:
Signature
Check air inlet and air outlet
The unit draws in air from the rear (Fig. 2) and blows it out again at the top.
(Fig. 2) Make sure that the air inlet and outlet are not blocked and check this each
time you start up the unit. Make sure that no objects or walls obstruct the air inlet or
outlet and observe the distance rules.
Check air filter:
This should be done every 2 weeks.
To do this, switch off the unit, disconnect the mains cable and remove
the water tank. You can now pull the filter downwards out of the unit.
Rinse the filter with warm (maximum 40°C) clear water and let it dry. Make sure that
the filter is not exposed to high temperatures and do not use cleaning agents or other
substances (such as petrol or alcohol). You can then reattach it to the unit.
1 2 3 4 5
2. Date:
Signature
6. Date:
Signature
10. Date:
Signature
14. Date:
Signature
6 7 8 9 10 11 12 13 14 15
3. Date:
Signature
7. Date:
Signature
11. Date:
Signature
15. Date:
Signature
4. Date:
Signature
8. Date:
Signature
12. Date:
Signature
16. Date:
Signature