Device Description; Installation Instructions - Comedes Demecto 70 Bedienungsanleitung

Device description

Figure 1
Control panel
ld
Air outlet Air outlet
Front cover

Installation Instructions

Operate the device only in rooms with at least 12m² floor space
Remove all adhesive tapes that were used for transport securing.
Check that the device is standing securely on a dry surface.
Make sure that the unit cannot cause water damage even if the water tank leaks.
Before starting up the appliance, always leave it in its final position for at least 2
hours to allow the coolant to cool down and to avoid the risk of compressor damage.
Check that the device is not exposed to direct sunlight. Check the float for correct
seating and ease of movement.
Make sure that the water tank is correctly seated.
Make sure that the power outlet is equipped with an RCD circuit breaker (ground fault
circuit interrupter). If
If you are not sure whether this is the case, you can ask your electrician or use a
personal protection plug (available at the hardware store).
To save power and avoid potential hazards, disconnect the unit when not in use.
Carrying handle
Figure 2
Air inlet /
Rear side of the
housing
Hose connection
Water tank