Hose Drainage; Recommendations For Drying With The Comedes Demecto 70 - Comedes Demecto 70 Bedienungsanleitung

Hose drainage

The Comedes Demecto 70 can also be operated
with a drainage hose. To do this, remove the water
tank and attach a drainage hose Ø12mm (not
included in the scope of delivery). Place it in the
recess on the tank, replace the tank and lead the
hose into a drain channel.
Make sure that the drain is not higher
than the connection on the appliance, so
that the water can drain away
undisturbed.

Recommendations for drying with the Comedes Demecto 70

To achieve the best possible dehumidification result with the Demecto 70 at
to achieve the lowest possible energy consumption, we provide the following
information:
Since this manual can only provide limited help, we recommend that you obtain
further information at:
Basics for dehumidification with the Comedes Demecto 70
The dehumidifier works similar to a refrigerator with a refrigerating machine. This
creates a cold surface (on the evaporator) on which water condenses.
Depending on air humidity and ambient temperature, the water condenses at the dew
point temperature. To enable the dehumidifier to dehumidify, the cold surface must
be below the dew point temperature. Since the water would freeze at negative dew
point temperatures, the dehumidifier can only work with positive dew point
temperatures. To ensure this, the dehumidifier is equipped with a modern,
temperature-controlled automatic defrosting system that keeps the evaporator
temperature between 0 and 5°C. To be able to dehumidify sensibly, the dew point
temperature should be above 5°C. If the dew point temperature is below this,
dehumidification is either not possible at all or only very inefficiently. With the
following table you can determine the dew point temperature
in your case. If the dew point temperatures are too low, heating is recommended.
Gas radiant heaters are not suitable in this case.
www.luftentfeuchter-tipps.de.