Comedes Demecto 70 Bedienungsanleitung Seite 26

automatically. By repeatedly pressing the "
30%, 35%, 40%, 45%, 50%, 55%, 60%, 65%, 70%, 75%, 80%, 85%, 90%
and AU can be set.
The hysteresis of the device is about 3%. During operation, the current humidity is
shown on the display. If the current humidity is
below 35% the display shows "LO". If the humidity is above 95%, the display shows
"HI".
memory function
The unit has a memory function that saves the fan speed and target humidity settings
when the unit is turned off. As soon as the dehumidifier is switched on again, it starts
up with the saved settings.
Continuous operation (CO.):
With the "CO" setting, the unit dehumidifies at maximum capacity and does not
switch off until the tank is full.
Comfort operation (AU):
With this setting, the unit operates in an automatic mode influenced by the
temperature.
1.at a temperature below 5°C the compressor stops.
2. at a temperature between 5°C and 20°C the target humidity is automatically
of 60%.
3. at a temperature between 20°C and 27°C a target humidity is automatically set
of 55%.
4. at a temperature above 27°C a target humidity of 50% is automatically stored.
Attention: After setting a value within the
no further button for the next 5 seconds to accept the setting
Empty water tank:
When the water tank is full, the Comedes
Demecto 70 switches off automatically and the
red LED ("Tank Full" indicator, Fig. 3) lights up.
You must empty the water tank to be able to use
the Demecto 70 again.
" button, a target humidity of CO,