Pattfield Ergo Tools PE-250 SHZ Originalbetriebsanleitung Seite 62

LIMIT BRACKETS
1 When the topmost position is reached,
the brake disc 13 causes the up limit
bracket 5 to shut down the motor.
Caution! Check the brake disc be-
fore use.
HOOK LATCHES
1 Make sure that the latches of the load
hook 9 is closed to secure the load.
Caution! Before use, check that the
load hook is not damaged or distor-
tional.
DOUBLE CABLE
1 Attach the additional load hook by re-
moving the 3 screws, placing the steel
cable around the deviating shaft below
the spring buffer unit 12. Reinsert and
tighten the screws securely.
LIFTING LOADS
1 1. Press to hoist the load upwards.
2. Press to lower the load.
Caution! Always stop the motor be-
for changing directions.
STEEL CABLE
1 Before use, check the steel cable for
damages.
A Cable is split
B Cable was bent
122 EN
2 When the hook is lowered to the extent
of almost using up the cable, the down
limit bracket 14 shuts down the motor.
Caution! Never unwind the cable
beyond the red indicator mark.
2 Attach the load hook 9 into the hook
bracket 15.
Caution! Make sure that the brake
disc is located above the additional
load hook.
2 In case of emergency, press the Emer-
gency-Off switch 6 to immediately stop
the motor. Turn clockwise to unlock
again.
Caution! Immediately stop the mo-
tor, if the load can not be hoisted.
2 Make sure that the steel cable is wound
up correctly on the cable drum.
Caution! A damaged steel cable
must be replaced by a qualified per-
son.
1
1
1
1 2
A
1
B
2
2
3
2
EN 123