Maintenance And Cleaning; Technical Data; Service Department - Kinzo X-Power Handbuch

A
• Place the tool onto the workbench.
• Secure the cable to prevent pulling the tool off the workbench.
• Carefully switch the tool on.
8.4 Cooling down
The nozzle and accessory become very hot during use. Let them cool down before attempting to move or
store the tool.
• To reduce the cooling time, switch the tool on at the lowest air temperature setting and let in run for a few
minutes.
• Switch the tool off and let it cool down for at least 30 minutes.

9 MAINTENANCE AND CLEANING

9.1 Cleaning
• Keep the ventilation slots of the machine clean to prevent overheating of the engine.
• Regularly clean the machine housing with a soft cloth, preferably after each use.
• Keep the ventilation slots free from dust and dirt.
• If the dirt does not come off use a soft cloth moistened with soapy water.
9.2 Lubrication
Your power tool requires no additional lubrication

10 TECHNICAL DATA

Voltage
Power supply
Air temperature/flow

11 SERVICE DEPARTMENT

• Damaged switches must be replaced by our after-sales service department.
• If the connecting cable (or mains plug) is damaged, it must be replaced by a special connecting cable
which is available from our service department. Replacement of the connecting cable should only be
carried out by our service department (see last page) or by a qualified specialist (qualified electrician).
12 STORAGE
• Thoroughly clean the whole machine and its accessories.
• Store it out of the reach of children, in a stable and secure position, in a cool and dry place, avoid too
high and too low temperatures.
• Protect it from exposure to direct sunlight. Keep it in the dark, if possible.
• Don't keep it in plastic bags to avoid humidity build-up.
6
71805 Manual.indd 6
Make sure that the nozzle always points away from you and any bystanders.
Make sure not to drop anything into the nozzle.
Attention !Before performing any work on the equipment, pull the power plug.
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may damage
the plastic parts.
230V / 50Hz
1600W
I 375°C / 400 l/min
II 495°C / 550 l/min
31-12-10 15:20