Disposal Of The Product - Kuppersberg FS 32 Technischer Pass

TECHNICAL PASSPORT
Built - in cooker
Figure 12.2
Fix the injector (D) to be converted as
shown in the Figure 12.2. (see table 1).
Figure 12.3
Replace the burner as shown in the
Figure 12.3.
Figure 12.4
Turn on the burners respectively after
conversion and remove the button on the
control panel and set the flame length by
tightening or loosening the screw on the gas
valve (12.4 cock) or in the valve shaft.
32

2.7. Disposal of the product

Destruction of the package
 Packaging materials are dangerous
for the children. Keep the packaging
materials at a place not accessible by the
children.
 The packaging of the product is
made of the recycled materials. And throw
them in the garbage by shorting out as per
the instructions on waste. Do not dispose
them together with the normal domestic
waste.
Future transportation operations
Keep the product in its original box and
carry the product in this box. Comply with
the instructions given on the box. If the
original cartoon is not available, wrap the
product with the blister packaging material
or a thick paperboard and tape it firmly.
 Fix the heads and pot supports firmly
with a tape.
 Do not put any object on the product.
The product should be carried upright.
 Control the general appearance of
the product for any damage that might have
occurred during transportation.
Disposal of the old product
 Dispose the old product in such
a way that it will not give damage to the
environment.
 A mark (WEEE) is present on this
product, indicating that the electric and
electronic equipment waste should be
collected separately. This means that the
equipment should be dealt with as per
EU Directive 2002/96/EC to recycle or
disintegrated into parts for minimising
its effect on the environment. For further
information, please contact with the local and
regional authorities.
ENGLISH