Starting The Outdoor Sensor / Changing Batteries; Starting The Main Station / Changing Batteries - OWIM HG05124A Bedienungs- Und Sicherheitshinweise

Starting the outdoor sensor /
changing batteries
Open the battery compartment
sensor by sliding the battery cover
When changing batteries first remove the old batteries.
Insert the new batteries, type LR06, in the battery compartment
Check the polarity of the battery during insertion. This is indicated
in the battery compartment.
Close the battery cover.
The signal LED
17
light up. The signal LED will then flash about twice a minute,
indicating wireless transmission.

Starting the main station / changing batteries

Open the battery cover
pulling up on the tab at the bottom of the battery compartment.
When changing batteries first remove the old batteries.
Insert the new batteries, type LR06, in the battery compartment
Check the polarity of the battery during insertion. This is indicated
in the battery compartment.
Close the battery cover.
The display
1
display elements.
Plug the low voltage plug of the mains adapter
adapter socket
31
into an easily accessible outlet. The display will permanently light
up and run a brief check of all display elements.
Note: Batteries power supply only for data backup only. When
you unplug the mains adaptor
not be delete.
at the front of the outdoor sensor will briefly
at the back of the main station by
5
will briefly light up and run a brief check of all
in the main station and plug the mains adapter
30
on the back of the outdoor
21
in the direction of the arrow.
18
30
, the storage setting value will
.
21
.
16
into the mains
GB 13