Search For Errors; Possible Cause - VINCENT SV-237MKII Bedienungsanleitung

Symptom
Unit does not work
after pressing the
power button
No sound on both
channels although
the unit is ready
for use (one of
the LEDs for the
input selection (7)
is lit).
No audio playback
on one channel
48

SEARCH FOR ERRORS

Possible Cause

Power cable is not connected to a suitable
wall outlet.
Power cable has not been firmly inserted into
wall power socket and the device's socket.
Otherwise it may be defective.
Unit fuse or unit is defective.
The currently selected audio source (4)(23) is
giving no signal.
One of the audio settings of a connected
DVD player (analogue/digital) has not been
correctly selected.
The output of the source device is not
connected or is wrongly connected e.g. not
connected to the selected input channel
terminal of the amplifier.
Wrong input channel has been selected at
the amplifier.
The Volume setting is set too low
The amplifier is muted (MUTE function).
The speaker cables are not properly
connected to the amplifier's terminals or are
defective.
The source equipment is giving signal on only
one channel.
One of the signal cables between audio
source and amplifier inputs has not yet been
plugged in or is defective.
One of the speaker cables is not correctly
connected or is defective.
Countermeasure
Connect to a functioning socket using a
suitable mains voltage.
Check the power cable. If necessary,
exchange it with a suitable power cable and
push its plug firmly into wall socket and the
device's power connector.
Contact your dealer.
Switch on the source unit and begin play-
back.
Correct the settings in the player's setup.
Correct the connection.
Set the amplifier to the input that your desired
source is connected to (4)(23).
Carefully increase the volume (5)(25).
Deactivate mute function ("MUTE" button
(22)).
Check and tighten the speaker cables at the
amplifier and at the speakers.
Check the audio source. You can try to use it at
a different amplifier for a test.
Check the cable connections, tighten them
if necessary.
Check and refasten the speaker cables at the
speaker terminal of the amplifier and at the
speaker's connectors. The cables coming
from both the speakers of a speaker pair must
not be connected to different terminal sets (e.g.
one A and one B) on the back of the amplifier.