Search For Errors; Possible Cause - VINCENT SV-228 Bedienungsanleitung

Symptom
Unit does not
work after pressing
the power button
No sound, appliance
is switched on (one
of the input LED's
on the front of
the device is lit)
No audio playback
on one channel
48

SEARCH FOR ERRORS

Possible Cause

Mains cable is not connected to a suitable
mains wall outlet.
Mains cable has not been firmly inserted into
wall power socket and the device's socket.
Otherwise it may be defective.
Unit fuse or unit is defective.
The currently selected audio source (1) (26)
is giving no signal.
One of the audio settings of a connected
DVD player (analogue/digital) has not been
correctly selected.
The output of the source device is not connec-
ted or is wrongly connected e.g. not connec-
ted to the selected input channel terminal of
the preamplifier.
Wrong input channel has been selected.
Volume setting is set too low.
The amplifier is muted (MUTE-Function).
A pair of headphones is still connected (10)
so the loudspeakers are switched off.
The loudspeakers connected have been
turned off with the "SPEAKERS" dial (4).
The speaker cables are not properly
connected to the amplifier's terminals or are
defective.
The source equipment is giving signal on only
one channel.
One of the signal cables between audio
source and preamplifier inputs has not yet
been plugged in or is defective.
One of the loudspeaker cables or one of the
signal cables between pre and main amplifier
is not correctly connected or it is faulty.
Countermeasure
Connect to a functioning socket using a
suitable mains voltage.
Check the power cable. If necessary, ex-
change it with a suitable mains cable and
push its plug firmly into wall socket and the
device's power connector.
Contact your dealer.
Switch on the source unit and begin play-
back.
Correct the settings in the player's setup.
Correct the connection.
Set the amplifier (1)(26) to the input that your
desired source is connected to.
Carefully increase the volume (3)(27).
Deactivate the MUTE function (25) after, as a
precaution, reducing the volume level.
Pull the headphone plug out of the device.
The volume should first be reduced for
safety's sake.
Move this dial to a suitable position for the
connected loudspeakers (e.g. "A" if a pair of
loudspeakers is connected to the clamps
"SPEAKER A" (21).
Check and tighten the speaker cables at the
amplifier (21) and the speakers.
Check the audio source. You can try to use it at
a different amplifier for a test.
Check the cable connections, tighten them if
necessary.
Check all the connections of the main amplifiers
and whether the loudspeakers are working.