Motorcontroller Fully Installed, Without Operating Power; With Network Power; Remote Control And Comfort Keypad; Wind/Rain Sensor - Window Master WCC 106 BT Installationsanleitung

14.1

MotorController fully installed, without operating power

1. Check all mechanical and electrical components for damage.
2. Check all screw and plug connections for tightness and/or firm seating.
3. Check that all external components are installed; check polarity for the ±24V actuators
14.2

With network power

Adhere to the relevant regulations!
Connect the mains cables and reapply the mains voltage.
14.3

Remote control and comfort keypad

Look closely at the actuators as they open and close - there must not be any obstacles in any position and the actuator connection
wires must not be overstrained with pulling or pinching.
Test the remote control and every single comfort keypad if installed.
14.4

Wind/rain sensor

1.
Open the actuators with the comfort keypads.
2.
Dampen the rain sensor, the actuators close completely.
3.
While the actuators are running, press Open button on the comfort keypad. The actuators must neither open nor stop.
If commissioning proceeds correctly, the lid of the MotorController may be fitted.
If commissioning does not proceed correctly, i.e. there is an error in one of the test points, refer to chapter "Connection description"
If necessary, re-test the cable routing in accordance with chapter "Connection plan for WCC 106 BT".

Maintenance

15
Control and maintenance should only be done by the manufacturer or an authorized partner.
Remove all soiling from the MotorController. Check fastening and clamping screws for firm seating.
Carry out a test run of the entire system (see chapter 19 'Commissioning and test run).
Only have defective units repaired in our factory. Only install original spare parts.
The expected minimum lifetime for the MotorController is 10 years.
15.1 Maintenance agreement
WindowMaster offers a maintenance agreement for MotorController. Contact our service department for further information:
Tel. +44 1536 614 070 or info.uk@windowmaster.com

Components declaration

16
The MotorController has been produced and tested in compliance with European guidelines.
The "Declaration of Conformity" is supplied with the MotorController as a separate document.
18