Oxygen Sensor; Fuel Evaporation Control System; Read Freeze Frame Data; Retrieve I / M Ready State - NEXSMART V322 Benutzerhandbuch

If you want to go on deleting the code, press Up/Down button to select, and press Return/Confirm
3
button. "Cancel the command" information is appeared. Press any button or wait for several seconds to
return to Diagnostic menu.

3.3 Oxygen sensor

(1) Use the up/down buttons to select the oxygen sensor diagnosis menu, and then press the return/enter
button.
(2) According to the test result, you can use the up/down buttons to view the current data flow.

3.4 Fuel Evaporation Control System

(1) Use the up/down buttons to select the fuel evaporation control system diagnosis menu, and then press
the return/enter button.
(2) According to the test result, you can use the up/down buttons to view the current data flow.

3.5 Read Freeze Frame data

(1) Press Up/Down button to select Freeze Frame diagnostic menu, and then press Return/Confirm button.

3.6 Retrieve I / M ready state

I/M ready function is used to check the operating situation of vehicle emission system that is accorded with
OBD II standard. This is a very good function before checking if the vehicle is accorded with the state
emission plan. Some newest vehicles models may support two types of I/M ready test:
A. DTC has been cleared - Shows the display status since DTC has been cleared.
B. This Drive Cycle - Shows the monitor status since the current drive cycle has been started.
I/M ready result is "No", it is not sure shows the tested vehicle can not pass the state I/M check. Some
states permit one or multiple such monitors are "Non-ready" passed the emission check.
"Confirm" - Shows the diagnostic test for the special monitor being checked has been finished.

"INC"- Shows the diagnostic test for the special monitor being checked has not been finished.

"Not applicable" - The vehicle doesn't support the monitor.

(1) Press Up/Down button to select I/M ready from Diagnostic menu, and then press Return/Confirm
7