Safety Measures And Warni; Decoder Operation; Tool Description; Specification - NEXSMART V322 Benutzerhandbuch

1.Safety measures and warning
For preventing physical injuries, or causing damage for the vehicles and decoder, please read this
operating manual before using this instrument on the vehicle, and comply with the following safety
measures:
(1) Detection shall be carried out in safe environment.
(2) Place a block plate in the front of the drive wheel, make sure the vehicle is guarded during operating
the test.
(3) Be more careful when operating near the ignition wire and spark plug of ignition coil distributor cover.
These components will generate the dangerous voltage when the engine is running.
(4) Place the gearbox in PARK (automatic gearbox) or NEUTRAL (manual gearbox), and make sure the
parking brake is connected.
(5) Do not connect or disconnect any test equipment when ignition switch is opening or engine is running.
(6) Keep decoder dry, clean, not adhere oil / water or lubricants.

2. Decoder operation

2.1 Tool description

(1) Diagnostic joint - Connect the decoder to the vehicle data link connector (DLC).
(2) LCD display - Display the detection result.
(3) DTC button- Diagnostic code
(4) Up roll button - Roll the menu and submenu in menu mode.
(5) Confirm button - When DTC covers multiple screens, confirm the selection (or operation) in the menu.
Applied to move down to the next screen to get the other data.
(6) BAT button - Battery Voltage
(7) Down roll button - Roll the menu and submenu in menu mode.
(8) Return button - Cancel the selection (or operation) in the menu or return to the menu. Long press for
3 seconds, it is also used to set the unit.

2.2 Specification

Display
Working temperature
Storage temperature
External power supply
Size
128 * 64 pixel
0~60℃（32~140℉）
-20~70℃（-4~158℉）
Vehicle batteries supply 9.0 to 16.0V
Length: 152mm, width: 87.5mm, height: 22mm
3