Read Code; Delete The Code - NEXSMART V322 Benutzerhandbuch

3.1 Read code

(1) Press Up/Down button to select the read code from diagnostic menu, and then press Return/Confirm
button.
（2）Press Up/Down button to select a module, and then press Return/Confirm button.
（3）Read DTC and its definition on the screen.
Control module No, diagnostic code order, total numbers of code to be detected and types of code (general
or specified by manufacturer, storage or code to be processed) will be displayed on the upper right corner
of screen.
If find out multiple DTC, please press Up/Down button by the requirements, until all
1
displayed.
If not detect the code, "Code is not stored in module!" information is displayed on the screen.
2
If the retrieved DTC contains any code specified by manufacturer or the enhanced codes, and then
3
"Controlled by manufacturer" is displayed on the screen.

3.2 Delete the code

Caution: Delete the diagnostic code will affect the normal use of OBD II. Please don't delete the
code before the technicians check the system completely.
(1) Implement this function by the key on (KOEO) engine. Do not start the engine.
(2) If decide to delete the diagnostic code, please press Up/Down button to select "Delete the code" from
the Diagnostic menu, and then press Return/Confirm button.
(3) A warning message appears, and needs you to confirm.
(4) If go on deleting the code, please press Return/Confirm button to delete.
If the code is deleted successfully, and then "Delete is finished !" information is displayed on the
1
screen.
If the code is not deleted successfully, and then "Delete is failed. Rotate the key in the case of engine
2
is turned off !" is displayed on the screen. Wait for several seconds or press any button to return to
Diagnostic menu.
6
codes are all