Operating Procedures - Matrix Sv4 Bedienungsanleitung

Operating Procedures

Fill the cold water tank (3) with clean cold water
only.
Anything other than clean cold
water used in the water tank will
void the manufacturer's
warranty.
Connect the Vacuum Hose to
the front of the machine (7) ensuring it locks into
position. To release the vacuum hose from the
socket slide the red button upwards at the same
time as pulling the hose out.
If the Hose becomes damaged the complete hose
must be replaced. Do not attempt this task
yourself, contact a Matrix approved supplier for
replacement.
Connect the Steam Hose to the front of the
machine (8)
Ensuring it is pushed in all the way and the pin on
the flap locks into the hole on the hose.
Ensure the steam hose
cannot be pulled out.
IMPORTANT
-
Grease "O" rings on steam pin before
connecting.
-
To release the steam hose, lift the flap
and pull.
-
Plug the power cable into a 240 Volt
supply.
IMPORTANT
-
Inspect the electric cable before every
use. If the cable becomes damaged at
any time the complete cable must be
replaced by a Matrix approved distributor.
- Never touch the power cable or plug with
wet hands
-
Always unplug the machine when the
machine is not in use when:
o Cleaning the machine
o Any maintenance work is being
carried out
Switch the On/Off switch (10) to the ON position.
The Heater On light LED (12) will illuminate.
Allow approximately 5 minutes for
the boiler to heat the water
When the Steam Ready LED (13) illuminates the
machine is ready to be used.
The handle controls are now active.
46