Front Axle - AsViva EKC2 Betriebsanleitung

ASSEMBLY
ATTACH THE FRONT WHEELS
4
Remove all parts from the front axle.
1. Slide the front wheel onto the front axle.
2. Slide the washer Ø12 onto the front axle.
3. Tighten the lock nut at the end of the front axle with a wrench.
4. Finally, clip on / snap in the hubcap.
Now repeat the work steps on the other side of the vehicle body.
GAP
32
2
3
After assembling any wheel to the axles, please check the
gap between the screw thread and the collapsible (refer to
below picture), if the gap is too big, please add two or three
washers inside the wheel, but after tightening the nut outside
the wheel, please turn the wheel by your finger to check if the
wheel can run smoothly, this is very important, because if the
wheel can run smoothly, it is ok, but if the nut press the wheel
and the wheel can't run smoothly, the motor will be broken
easily! Then you need to decrease one or two washers to
make sure the wheel can run smoothly!

Front axle

1
Front Bottom View