AsViva EKC2 Betriebsanleitung Seite 31

ASSEMBLY
ATTACH THE DRIVE WHEELS
Rear axle
Rear Bottom View
1. Plug the gearbox onto the rear axle. Pull out the plug on the gearbox through the larger hole and where the
battery is located.
2. Connect the cable of the gearbox to the cable in the interior of the vehicle.
3. Put the drive wheel on the rear axle. Make sure that it is aligned with the gearbox.
4. Fix the wheel with a Ø12 washer and a lock nut which you also place on the rear axle.
5. Tighten them with a wrench.
[HINT: An extra wrench is provided to hold the lock nut on the other side of the rear axle while you tighten the
lock nut on the other side].
6. Finally, clip on / snap in the hubcap.
Now repeat the work steps on the other side of the vehicle body.
1
2
3
4
9
31