Settings For The Control Unit; Menu Control; Standby Mode; Changing Settings - Carpetlight CL21 Bedienungsanleitung

SETTINGS FOR THE CONTROL UNIT

The following settings refer to firmware version 4.0. The firmware version is displayed
during startup of the device and can also be reviewed using the respective menu item.
After successful connection of lamp head, control unit und power supply, the lamp is
ready for operation. Once the main switch on the control unit has been activated, the
CARPETLIGHT logo will appear in the display. The lamp always starts in the On-mode
and will apply the brightnessꢀ ꢀ andꢀ ꢀ color ꢀ ꢀ t emperature settings used last.
Button: Save / Open menu / Standby
•
Left encoder: Brightness / Menu control
•
Right encoder: Color Temperature / Values
•
To adjust the brightness, please use the left encoder. By turning the encoder, the
desired dimming range can be set and the respective values will be displayed. The color
temperature settings are adjusted using the right encoder. The values can be seen in
the display and are measured in Kelvin (K), controlled in 50 K increments and displayed
in 100 K increments. The small square showing up next to the value while continuously
adjusting the knob indicates the 50 K increments.
Briefly pressing ꢀ ꢀ d own ꢀ ꢀ t heꢀ ꢀ standby/menu ꢀ ꢀ b utton will ꢀ ꢀ p ut ꢀ ꢀ t he ꢀ ꢀ l amp ꢀ ꢀ i ntoꢀ ꢀ standbyꢀ ꢀ modeꢀ ꢀ
andꢀ ꢀ the lamp can be switched off in the current setting. Pressing down the button
again will turn the light back on to its previous setting before the lamp was turned off.
By pressing down the standby/menu button for 3 seconds you enter the options menu.
Pressing down the standby/menu button again for 3 seconds will bring the lamp back
into operation mode.
ATTENTION: Unsaved changes in settings will be lost by this step.
In the options menu you can now browse through the menu items by turning the left
encoder. Turning the right encoder will change the respective values. By briefly
pressing the standby/menu button the set values will be stored. This will be confirmed
byꢀtheꢀdisplayꢀ"saved"ꢀinꢀthe upper right corner of the screen.

Menu control

Adjusting brightness and color temperature

Standby mode

Changing settings

27