Settings For The Control Unit; Switching On/Off And Standby-Mode; Selection Using The Menu Function/Standby-Mode - Carpetlight CARPETINO Bedienungsanleitung

settings fOR the COntROl unit

Brightness Display
Color Temperature
Control
Control
The use of these settings is for version 3.13 of the firmware.
The settings could change in the future. If your firmware is a different version than 3.13,
please contact CARPETLIGHT GmbH.

switching On/Off and standby-mode

Once the lamp is successfully connected to the control unit and that is connected to a
functioning power supply, the lamp is ready for use.
Brightness and Color temperature
For setting the brightness please use the brightness control knob and by turning this the
desired dimming range can be read in the display.
For setting the color temperature please use the color temperature control knob.
The color temperature can be seen in the display and is measured in Kelvin (K), and can
be controlled in 100 K increments.

selection using the menu function/standby-mode

pressing down briefly the stand-by button will put the lamp into Stand-By Mode and
switch the lamp off. pressing down on the button briefly again will turn the light back
on to its exact previous setup before the lamp was put into standby-mode. By pressing
down the color temperature control knob for 3 seconds you are now in the options
menu. By pressing down the color temperature control knob for another 3 seconds you
are then in the lamp operation mode.
Once in the options menu, using a short press of the color temperature control knob
you can go through the menu functions. Use the brightness control knob to change
menu functions and its corresponding value.
23