Assembly Of The Lamp; Mounting The Lamp Cl21; Mounting The Lamps Cl42 And Cl44; Mounting The Lamps Cl84 And Cl8X8 - Carpetlight CL21 Bedienungsanleitung

ASSEMBLY OF THE LAMP

The assembly and changing of the ancillary equipment is to be carried out from a stable
position.
Mouting the lamp CL21
Assembly of the frame for CL21: Fold the four arms away from the central frame cross
and snap them into place. The four velcro strips and the velcro surface of the frame
cross are located on the front of the frame.
We recommend that you always operate the lamp in frame mode using the threaded
pins provided. Align the velcro strips of the lamp with the velcro surfaces of the frame
and press them on.
When fixing, please always start with the pin in the corner where the cable leaves the
lamp. Insert the set screw through the oval eyelet of the lamp head and loosely screw
it to the ¼ inch threaded receptacle of the frame. Once all 4 setscrews are loosely
screwed in, the ¼ inch threaded receptacles can be pushed further out to provide
basic tension to the lamp/frame system. Tighten both the setscrews and the wing
screws.
Attaching the CL21 spigot: The 16mm spigot is attached to the centre of the frame
using a bayonet mount. The spigot is placed within the fastener, turned slightly then
tightened using the union nut.

Mounting the lamps CL42 and CL44

Assembly of the frame for CL42 and CL44: Place the respective pipes successively on
the cross and fix them with the fastening screws. Insert the spigot into the cross and
lock it with the locking pin (when delivered the spigot is already mounted). Move in the
pull-outs at the end of the pipes as far as possible, mount the lamp onto the hooks
and tighten the lamp using the pull-outs. To use a softbox, insert the pins at the end
of the pull-outs. To release the pins, briefly pull the locking knob on the back.

Mounting the lamps CL84 and CL8x8

Spanning the lamp: The lamp heads of CL84 and CL8x8 lamps can be mounted on any
standard 8x8 frame using the bungee cords supplied. Please take safety precautions
of the lamps contact surface with respect to windy weather conditions!
Folding and packing the lamp head: Place both sides on which the cables leave on top
of each other, with the light emitting side facing inwards. Then lamp can then be
quatered or directly rolled up and stowed in the provided bag.
23