Makita HR4501C Betriebsanleitung Seite 9

Model HR4511C
Vibration
Work mode
emission
8.3 m/s
Hammer drilling
into concrete
(a ) 8.1 m/s
h, HD
7.1 m/s
Chiselling
function with side
handle (a )
6.8 m/s
h, CHeq
7.0 m/s
Chiselling
function with side
grip (a ) 8.1 m/s
h, CHeq
* The test condition of recommended practical operation
meets EN 62841-2-6, except for the following points:
• Feed force is applied to the switch handle (main
handle) for working accuracy and efficiency.
• The side grip/handle (auxiliary handle) is held to keep
balance of the tool.
• The declared vibration total value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
• The declared vibration total value(s) may also be used
in a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the
power tool can differ from the declared value(s)
depending on the ways in which the tool is used
especially what kind of workpiece is processed.
• Be sure to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
EC Declaration of Conformity
For European countries only
The EC declaration of conformity is included as Annex A
to this instruction manual.
Applicable
Uncertainty standard /
(K) Test
condition
2 2
EN 62841-2-6
1.5 m/s
Recommended
2 2
practical
1.5 m/s
operation*
2 2
EN 62841-2-6
1.5 m/s
Recommended
2 2
practical
1.5 m/s
operation*
2 2
EN 62841-2-6
1.5 m/s
Recommended
2 2
practical
1.5 m/s
operation*
ENG901-2
9