Panasonic PAW-FC-RC1 Installationsanleitung Seite 4

Symbol
The display can be in 3 modes, when controller state is Occupied or Standby :
• Active mode: The controller is activated, but no changes are made now. The display shows either
the current room temperature (standard) or the calculated setpoint (if parameter P045 is set to 0).
• Setpoint mode: This mode is activated when pressing one of the arrows when in Active mode.
Either the calculated setpoint ± adjustment (standard) or the current user defined setpoint
adjustment (if P046 = 1) are shown.
• Idle mode: The controller has been inactive during a set time span (activatable with P044 > 0
seconds). All buttons and segments, except the two arrows, are dimmed down in the display.
4
On/Off button
Arrow up = increase button for
setpoint adjustment +
Arrow down = decrease button for
setpoint adjustment -
Changeover button to switch between heating and cooling via the
display
Fan button to regulate the fan speed via the display between AUTO /
MAN (off/1/2/3)
Description
for start parameter list: press
both together until the display
shows 0000, then short "up" to
show P001