Control Panel; Display - AXSOL ARVEY E-Serie Bedienungsanleitung Und Garantieerklärung

3

Control panel

The red main switch is located on the control
panel. When this is pressed for at least 2
seconds, the device starts up and is ready to use.
The device is also switched off again with the
main switch.
Important information on the status of the device
and electrical measured values are also displayed
on the control panel. Settings can also be made
on the device here.
Figure 13 elements control panel
Figure 14 alternative icons
1
1) Status display LEDs
2) Display of measured values
2
3) Display of operating mode
3
4) Main switch
5) Menu keys
4
3.1

Display

5
The following information and electrical measured
values can be read on the display:
•
Operating mode
•
Input voltage
•
Output voltage
•
Frequency
•
Output power
•
Battery charge level
•
Photovoltaic power
•
Photovoltaic current
•
Photovoltaic Voltage
•
Error codes
The various measured values can be displayed
using the Up/Down menu keys.
In addition, the current operating mode is shown
on the display in a block diagram. Depending on
the current operating mode, the following
symbols are displayed:
1
2
3
4
Figure 15 block diagram symbols
Meaning of the symbols of the block diagram:
1) Battery charger
2) 230 V alternating current source
3) Photovoltaic
4) Photovoltaic controller
5) Bypass active
6) Battery
7) 230 V consumer
5
6
7
27