Troubleshooting - GLOBALO Silentio 60 Gebrauchs- Und Montageanleitung

Before connecting the service, please take down the following details of your device:
Type:
Seria-Nr:
You can find this information on the identification plate. The plate is located inside the hood and
is visible after removing the metal filters.
The identification plate shown in the figure above is only an example. The data may differ for
other models.
To request a hood repair, you can use the form available at https://globalo.pl/serwis/.

TROUBLESHOOTING

Problem
When the hood is operating, a flashing „F"
appears on the display*.
The display only shows
the „-." sign (minus and dot in the lower
right corner), the hood does not start
when switched on*.
No sign appears on the display, the hood
does not respond to the buttons*.
The display shows the sign of one of the
speed levels and the hood does not react
to the buttons*.
The hood turbine switches off after
15min. of operation and the display blinks
with, for instance „1" (the number of the
current speed level and a dot in the lower
right corner of the display*.
___________________
___________________
Tyoe
Lighting power
Supply Voltage /
frequency
Outlet diameter
Seria-Nr
GLOBALO MAX
Ul. Maków 10
38-500 Sanok
After 35 hours of operation, the display
indicates that the anti-grease filter needs
to be cleaned or replaced.
The touch panel is locked (this is a
function used to facilitate cleaning of
The control panel may be frozen.
The control panel may be frozen.
The automatic timer of the control panel
SILENTIO 60
5 W
220-240V/50Hz
Ø15 cm
7350001
Possible reason
the hood).
has been activated.
Solution
Press and hold down for approx.
6s the „-" button on the panel. Clean the
filter or replace it with a new one.
To deactivate the lock, press and hold the
on/off sign for approx. 10s.
Disconnect the hood from the power
supply for approx. 15 seconds and then
switch it on again.
Disconnect the hood from the power
supply for approx. 15 seconds and then
switch it on again.
To deactivate the timer, press the plus
sign for about 10 seconds or switch off
the device.
EN
35