Nobex Mitre Saw Instr Uctions - Nobex Champion 180 Gebrauchsanleitung

Nobex Mitre Saw instr uctions

The general purpose is to cut material in exact planes and with
exact angles.
Typical fields of applications are:
• Furnishing of houses (architrave, skirting, cornices, etc.)
• Picture framing (4, 5, 6, 8 or 12 corners)
• Wooden fences
• Installation of electric panels
• Plumbing (cutting of copper and plastic pipes)
• Mirror framing
• Joinery (furniture and clocks)
• Model making
• Steel constructions
How to assemble – see enclosed assembly instructions
Description of the main parts
The shaping of the saw blade is of importance to obtain a good result and a
minimum of resistance.
There are four different hard point blades available and one bi-metal
blade:
Product Name Article no.
Champion CH-10
Royal & Proman PRM-12
Champion CH-18
Royal & Proman PRM-18
Champion CH-24
Royal & Proman PRM-24
Champion CH-32
Royal & Proman PRM-32
Champion CH-24Bi
On both Royal 125 and Champion 180 you have full height support from the
extended fences.
Compound action – patented technique for easy compound mitre cuts. The
saw base has cast slots for making compound mitres. This is achieved by
placing one edge of the work piece into one of the slots on the horizontal
surface and the flat side against the edge of the vertical wall. The angle
against the vertical plane is marked for each slot. (Picture A)
The extended fences on Royal 125 and Champion 180 must be taken off
when making compound mitres.
Pre-set locking – quick and accurate for 4, 5, 6, 8, and 12-sided frames and
90° cuts. Release the catch that locks the saw blade at a certain angle and
then let it "click" into the desired angle position.
Stepless locking – locks at any angle between pre-set stops. Turn the red
lever on the back of the base to lock at a certain angle (not on Proman
110). (Picture B)
No. of teeth Application
10 t / inch Carpentry fast. Fast cutting on
12 t / inch large work pieces such as
joists and studding timbers.
18 t / inch Carpentry general. Architrave,
skirting and plastic pipe
works.
24 t / inch Picture framing. Wooden
picture frames and mouldings.
32 t / inch Non ferrous metal. Aluminium,
copper, brass and cutting the
thinnest materials.
24 t / inch For ferrous metal. Steel rods,
steel tubes and steel cutting.
1