Identity Card - SECURX SECUR1 Bedienungsanleitung

especially: - trailing or looping of lanyards or lifelines over sharp edges, - any defects like
cutting, abrasion, corrosion, - climatic exposure, - pendulum falls, - extremes of
temperature, - chemical reagents, - electrical conductivity.
!
personal protective equipment must be transported in the package (e.g.: bag made of
moisture-proof textile or foil bag or cases made of steel or plastic) to protect it against
damage or moisture.
!
the equipment can be cleaned without causing adverse effect on the materials in the
manufacture of the equipment. For textile products use mild detergents for delicate
fabrics, wash by hand or in a machine and rinse in water. For energy absorbers use only a
damp cloth to wipe away dirt. It's forbidden to immerse energy absorbers into the water.
Plastic parts can be cleaned only with water. When the equipment becomes wet, either
from being in use or when due cleaning, it shall be allowed to dry naturally, and shall be
kept away from direct heat. In metallic products some mechanic parts (spring, pin, hinge,
etc.) can be regularly slightly lubricated to ensure better operation.
!
personal protective equipment should be stored loosely packed, in a well-ventilated
place, protected from direct light, ultraviolet degradation, damp environment, sharp edges,
extreme temperatures and corrosive or aggressive substances.
!
U sing the harness in connection with
height must be compatible with manual instructions of
- EN353-1, EN353-2, EN355, EN354, EN360 - for the fall arrest systems;
- EN362 - for the connectors;
- EN1496, EN341 - for rescue devices;
- EN795 - for anchor devices.
Manufacturer:
PROF-PRAXIS NV/SA Scheibeekstraat 25-29, 1540 Herne, Belgium -
sales@prof-praxis.com
Notified body for U E type examination
APAVE SUD EUROPE SAS (no 0082)
MARSEILLE CEDEX 16 - France
Notified body for control production:
APAVE SUD EUROPE SAS (no 0082)
MARSEILLE CEDEX 16 - France
EU declaration of conformity
www.prof-praxis.com
personal protective equipment agains falls from a
this equipment and obligatory standards:
according to PPE Regulation 2016/425:
– –
CS 60193 F13322
– –
CS 60193 F13322

IDENTITY CARD

It is the responsibility of the user organisation to provide the identity card and to fill in the
details required. The identity card should be filled in before the first use by a competent
person, responsible inthe user organization for protective equipment. Any information about
the equipment like periodic inspections, repairs, reasons of equipment's withdra
shall be noted into the identity card by a competent person
identity card should be stor ed during a whole period of equipment utilization. Do not use the
equipment without the identity card.
MODEL AND TYPE OF EQUIPMENT
SERIAL /BATCH NUMBER
REFERENCE NUMBER
DATE OF MANUFACURE
DATE OF PURCHASE
DATE OF FIRST USE
USER NAME
PERIODIC INSPECTION
DATE OF REASON FOR DEFECTS
INSPECTION INSPECTION CONDITION
OR REPAIR REPAIRS CARRIED OUT
wal
in the user organization.
AND REPAIR HISTORY CARD
, NAME AND SIGNATURE NEXT
NOTED OF COMPETENT INSPECTION
DATE
PERSON
from use
The