Memory Function - ofinto Elevate Bedienungsanleitung

USE
INITIALIZATION
When the ofinto Elevate is used for the first time, the system must
be initialized. To do this, simultaneously hold down the and
^
keys until the table has reached its lowest possible height and you
hear a short beep (takes about three seconds).
HEIGHT DISPLAY
The display of the control panel shows the current height of the
table top. This display works both in centimeters and inches. To
change the unit system, press and hold the , and keys simul-
1 2 M
taneously until «C-E» flashes on the display. Then, press the key
1
for centimeters or the key for inches.
2
ADJUSTING THE TABLE HEIGHT
The control element allows you to set the table height using the
^
and keys. On the display, you can see the current height of the
table top.

MEMORY FUNCTION

You have the option of saving up to four table positions for later
use. To do this, use the arrow keys to set the desired height and
then press and hold the key until the number on the display
M
starts to flash. Then, press the , , or key to save the current
1 2 3 4
E
table position under this key., um die die Höhe unter dieser Taste
zu speichern. The height remains stored even when the table is
temporarily without power.
21