Drain Tank - Agrilution Plantcube Bedienungsanleitung

Drain tank

56
1. Preparation
Fit the drainage tube and guide the other end
into a large vessel such as a bucket or a wate-
ring can (not included).
2. Pump out the water
Activate the drain tank mode using the app or
by pressing and holding the function button
for approximately 10 seconds. As soon as the
function button is continuously illuminated,
start or interrupt the pumping with a short
press of the button.

Make sure that you pause the emptying
process before the collection vessel overflows.
To do this, simply press the function button
again.

Water that has been pumped out is ideal to
use for watering your house plants or similar.
To exit the drain tank mode, exit this mode in
the app or hold the function button for ap-
proximately 3 seconds. This mode is no longer
active when the function button is no longer
illuminated.

Once you have removed the tube from the
water inlet, make sure that any water still re-
maining in the tube is completely emptied into
the collection vessel.
3. Removing the water tank
1. Lift and pull
2. Pull out

Ensure that the water level in the tank does
not exceed approximately 5 cm. Water will
automatically cease to be pumped out when
the appliance detects that the tank level has
reached its minimum.

Take care to avoid spilling water when car-
rying the tank if any water is left in it.
Then pour away the remaining water.
EN
57