Filling The Water Tank - Agrilution Plantcube Bedienungsanleitung

50

3. Filling the water tank

Add cold tap water until the water level indica-
tor is completely green.

Before filling the tank with water, check that
there is no water in the plant drawers. Only
once all the water has returned to the tank
from the plant drawers may you add water as
needed.

The tank's full capacity is approximately 17
litres.

Always ensure that the tank has been
correctly inserted and that there is sufficient
water in the appliance. The app will notify you
when the water needs to be topped up.
4. Inserting the backflow filter

Rinse out the backflow filter carefully at
least every two weeks.
5. Inserting plant drawers
1. Push in the drawer runners fully
2. Insert the plant drawer by pushing it evenly
on both sides into the appliance at a slight
downward angle
3. When the drawer is fully inside, press the
drawer down a little more firmly with both
hands until it locks into place
4. Insert the individual Seedbar holders into
the cover sheet and place it on the plant dra-
wer in the device

While the appliance is in operation, both
plant drawers must be correctly inserted in
the appliance at all times. Otherwise, this may
cause flooding and watering issues.

Ensure that the water inlet protrudes out
at the back of the plant drawer and that the
drawer sits firmly on the runners, otherwise
watering issues may occur.
EN
51