Information About The Device; Description Of The Device - Trotec DH 95 S Bedienungsanleitung

Information about the device

Description of the device

This device uses the principle of condensation to au-
tomatically dehumidify rooms.
The fan sucks damp room air through the air inlet (5),
the air filter (6), the evaporator and to the condenser
located behind it. The air is cooled at the cold evapo-
rator until it is below the dew point. Water vapour con-
tained in the room air precipitates on the evaporator
fins as either condensation or frost. The dehumidified,
cooled air is rewarmed at the condenser and blown
out at a temperature of approx. 5 °C above room tem-
perature. The drier air which is prepared in this way
mixes with the air in the room. The humidity in the
room where the device is positioned is reduced as air
constantly circulates through the device. Depending
on the air temperature and the relative humidity, the
condensed water either drops continuously or only
during the defrost phase into the condensation tray.
The condensation is fed through a pressure-resistant
pipe connection and out of the device by a condensa-
tion pump. To do so, a condensation drain hose is
connected to the hose connection (7) and the conden-
sation is diverted.
The condensation pump is fitted with a float switch. It
switches off the condenser dryer when a certain fill
level in the condensation tank is reached. A beep is
emitted and an indicator light is lit. The condenser
dryer must then be switched back on by hand.
The device has a control panel (1) for operating and
controlling the functions.
The device can reduce the relative humidity of a room
by up to approx. 30 %. Because of the heat radiation
which is tied up in operation, the room temperature
can rise by approx. 1-3 °C.
GB
Device depiction
5
4
7
2
No. Operating element
1 control panel
2 air outlet
3 power cable
4 wheels
5 air inlet
6 air filter
7 hose connection for condensation drain hose
Operating manual – Condenser dryer DH 95 S
1
2
3
5
6
B - 2